Lenovo ThinkServer TD200 Uživatelský manuál Strana 33
- Strana / 228
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Chapter 4. Server controls, LEDs, and power
This section describes the controls, light-emitting diodes (LEDs), and connectors on
the front and rear of the server, and how to turn the server on and off. For the
location of the LEDs on the system board, see “System-board LEDs” on page 33.
Note: The illustrations in this document might differ slightly from your model.
Front view
The following illustrations show the controls, LEDs, and connectors on the front of
the server models.
The following is an illustration of the 3.5-inch SAS/SATA hot-swap hard disk drive
model:
1 Power-on LED 7 DVD-eject button
2 Power-control button 8 Hard disk drive activity LED (green)
3 Hard disk drive activity LED 9 Hard disk drive status LED (amber)
4 System-error LED 10 DVD drive activity LED (green)
5 USB 2 11 Front information panel
6 USB 1
The following is an illustration of the 2.5-inch SAS/SATA hot-swap hard disk drive
model:
© Lenovo 2009. Portions © IBM Corp. 2009. 15
- Installation and User Guide 1
- Contents 5
- Contents v 7
- Safety ix 11
- Safety xi 13
- Safety xiii 15
- Safety xv 17
- Chapter 1. Introduction 19
- Related documentation 21
- Features and technologies 25
- Specifications 27
- Software 30
- EasyStartup 30
- EasyManage 30
- Front view 33
- 1 Power-on LED 6 USB 1 35
- Operator information panel 37
- EasyLED diagnostic panel 38
- Rear view 44
- System-board LEDs 51
- Server power features 53
- Turning on the server 53
- Turning off the server 53
- Installation guidelines 55
- System reliability guidelines 56
- Opening the bezel 58
- Removing the side cover 61
- Removing the air baffle 62
- 1 Fan cage assembly 65
- 2 Power-supply release tab 70
- 2 Hinge pins 71
- Removing the battery 72
- Installing the battery 73
- 1 Positive (+) side 74
- Removing a DVD drive 77
- Installing a DVD drive 80
- 1 EMC shield 82
- 2 Optical drive 82
- 3 Optical drive rails 82
- 1 Optical drive power cable 83
- 2 Tape drive 86
- 3 Drive tray 89
- 4 Hard disk drive 89
- 2 Drive tray 90
- 4 Release latch 90
- 5 Hard disk drive 90
- 1 Filler panels 94
- 2 Drive-bay EMC shield 94
- Removing a power supply 97
- Installing a power supply 100
- 2 Power supply assembly 101
- Removing a hot-swap fan 102
- Installing a hot-swap fan 103
- Removing a memory module 104
- 1 Power supply 105
- 2 Power-supply handle 105
- Installing a memory module 107
- 12 Dual-rank DIMMs 4 GB 48 GB 108
- 1 DIMM 112
- 2 Retaining clip 112
- Removing an adapter 113
- Installing an adapter 114
- 1 Adapter 117
- 1 Microprocessor 121
- 2 Alignment triangles 121
- 3 Notches 121
- 2 Power supply release tab 123
- 2 PCI slot 1 125
- 1 Adapter connector 128
- 2 Signal cable 128
- 1 ServeRAID adapter 131
- 2 Battery carrier 131
- 3 Battery 131
- 1 Alignment bracket 144
- 2 Virtual media key (rear) 144
- 3 Virtual media key (front) 144
- 4 Retention tab 144
- 1 Release latch 147
- 2 Control panel assembly 147
- Completing the installation 148
- Closing the bezel 148
- 1 Bezel 149
- 2 Hinge assembly 149
- 3 Retention tabs 149
- Installing the air baffle 150
- 1 Air baffle pinch tab 151
- 2 Air baffle 151
- Installing the side cover 152
- Connecting the cables 152
- Connecting external devices 154
- Using the Setup Utility 156
- Starting the Setup Utility 156
- Setup Utility menu choices 156
- Passwords 159
- Configuring RAID controllers 160
- Formatting a hard disk drive 162
- Using the WebBIOS utility 163
- Starting the WebBIOS utility 163
- Using the EasyStartup DVD 165
- Configuring RAID 166
- EasyStartup overview 166
- Updating the firmware 169
- 2 Clear CMOS jumper (JP1) 171
- 3 SW6 switch block 171
- Automated boot recovery (ABR) 172
- Three boot failure 172
- Installation requirements 178
- Installation order 178
- Chapter 7. Troubleshooting 181
- Diskette drive problems 182
- General problems 183
- Hard disk drive problems 183
- Intermittent problems 184
- Memory problems 185
- Microprocessor problems 186
- Monitor or video problems 186
- Optional-device problems 188
- Power problems 189
- Serial port problems 190
- Software problems 191
- Solving undetermined problems 191
- Solving SCSI problems 192
- Solving power problems 193
- Event logs 194
- POST error codes 196
- Before you call 205
- Using the documentation 205
- Calling for service 206
- Using other services 206
- Lenovo product service 207
- Appendix B. Notices 209
- Trademarks 210
- Important notes 210
- Appendix B. Notices 193 211
- Hazardous Substances 212
- Battery return program 213
- Appendix B. Notices 197 215
- Appendix B. Notices 199 217
- Index 203 221
- Index 205 223
- Index 207 225
- Part Number: 44W2344 228
- Printed in USA 228
- (1P) P/N: 44W2344 228
Související produkty a manuály pro Počítačový hardware Lenovo ThinkServer TD200
(36 stránky)
(80 stránky)© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.080 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce